Pomp and Circumstance
Finally. She is complete. My longest unfinished project is a little rough but she is ready.
Don’t look too close; you’ll see that I didn’t make this one to speculation. That multitude of plants I had left to built? I didn’t make them all. I made a few but quickly grew tired and frustrated at all the small paper pieces, so I made my own variations or duplicates with extra pieces.
There were some rookie mistakes - remember, this was initially my first kit - including the flooring. I glued the flooring paper to the wrong side of the floorboard. I didn’t realize it mattered until I was trying to fit everything together and noticed that notches on the floorboard weren’t linking into the walls. Oops. You can see I just flipped it over and accepted the wood flooring piece as the floor.
I also had to tip the whole thing upside down to fit in some of the ceiling wiring and didn’t realize until too late that the hanging light got tilted.
Honestly, I was glad when I finished this one. I had a hard time not doing every single plant to the instructions, but I got to a point where I was putting all the pieces in the room and realized that no one would miss a plant or two. No one would realize I had replaced a finicky design with something a little easier.
I’m not planning on putting this in the Louvre, so it doesn’t have to be perfect. Its main purpose is my enjoyment, so I could decide when it was good enough for me.
It’s still super cute and when they’re all lined up, you can’t see the imperfections. It’s a mini kit so dexterity is important, but I’d say even more so with this one. There was a lot of rolling up tiny squares of flimsy paper, so you want to have that patience and ability.
Next up will be something different. We’ll take a break from minis for a bit. I could use the break and so could my hands.
Project Notes:
Link - $39.99
Difficulty level: 5/5 (I’m calling it)
Time commitment: a Week (because you’re going to need to take breaks)
Bonus:
Because the batteries came in this kit, I did test my last kit to make sure I had wired it correctly: